User's Manual

50D0096 Rev 0 Aug 2005 Page 4 of 10 Ambient Technologies
A Division Of
Monessen Hearth Systems
Back of the Transmitter
Battery
Door
Tab
WARNING
STOP: Make sure 120VAC fan and MV valve are correct. If not wired correctly, this could
cause damage to receiver.
Make sure that the wires do not contact the appliances any place other than at the terminals.
Exposure to temperatures higher than 105C (250ºF) may cause the receiver to malfunction
and cause possible fire hazard.
Remote Transmitter
:
Installing Batteries:
The remote transmitter uses three (3) “AAA”- size batteries.
To install batteries,
1. Press down the battery door tab and pull out to remove the battery door.
2. Install the batteries as indicated on transmitter.
3. Close the battery door by snapping in place.
4. When three batteries are installed, the transmitter will initialize for 10
seconds and then is ready for use.
5. The batteries should be replaced at least once every 6 months or when the
low battery icon indicator is displayed.
Receiver
MV Valve
Blower