User's Manual

Fireplace new platform product specification
Copyright © 2014 Computime Limited. All rights reserved. Rev. 1.2
Page 5
3.1.7 Auto mode: Press the AUTO button to enter the thermostatic mode. SET icon will be
appeared on the lower LCD screen. In thermostatic mode, press ON button or OFF button to set the
desired set temperature. Once the setting is completed, the transmitter will be automatically turned
on the fireplace when the room temperature is below the set temperature. The transmitter will be
turned off when above the set temperature. The temperature range is within 1 degree. There will be
a slight delay in the response of the unit (on/off) to a temperature. Room temperature is monitored
every 3 minutes. Press the AUTO button to exit the thermostatic mode. The SET icon will be
disappeared on the LCD display. The transmitter will be in the manual on/off mode. The AUTO
mode only for ModelB_Tx1.
3.1.8 Timer mode: Press the Timer button to start the timer, 90 min as shown in LCD and SET icon
below 90 in LCD. 2
ND
press the Timer button, the timer will be set to 60 min, 3
rd
press the timer
button the timer will be set to 30 min. Three seconds later, the tranmsitter will be turn on the
fireplace.
Once the timer is 0 min, the transmitter will be send off signal and turn off the fireplace.
Press the OFF button to exit the timer mode and the transmitter will be shut off the fireplace.
3.1.9 Room temperature: Show the current room temperature, display temperature range: 40℉-99℉
(5-37℃), accuracy is +/-1℃. every 3 minute to check the room temperature.
3.1.10 The temperature setting range are 45℉-90℉(7-32℃).
3.1.11 Low battery: When the battery voltage of remote is less than 3.4V, the low battery icon will
be shown. The battery will be checked every minute. If the battery voltage of remote is less than
3.2V, the remote will send the flame OFF command to the receiver and turn off the flame.
3.1.12 Child lock - When press and hold the ON and OFF buttons for 3 seconds, the
remote will be locked, the LCD will show the child lock icon and current status, and user cannot
change any setting when pressing the buttons. It will be unlocked when press and hold the ON and
OFF buttons again for 3 seconds.