User's Manual

50D0098 RCSITE Installation & Operating Manual
Rel 0 Dec 2005
Page 8 of 10
Ambient Technologies
A Division Of Monessen Hearth Systems
TESTING YOUR NEW REMOTE CONTROL SYSTEM
1. Light your gas appliance following the appliance lighting instructions that came with the appliance.
Confirm that the pilot light is on; it must be in operation for the remote control to operate the main gas
valve. Appliance control knob must be in the ON position, and appliance ON/OFF switch must be in OFF
position.
2. Slide the 3 position button on the remote receiver to the ON position and the main gas flame should ignite.
3. Slide the button to OFF and the main gas flame should extinguish, but the pilot light will remain on.
4. Slide the button to RS (the center position), then press the ON button on transmitter to turn the system ON.
The main gas flame should ignite.
5. Press the OFF button on transmitter and hold to turn the system to OFF. The flame should extinguish (the
pilot light will remain on).
TROUBLESHOOTING
Symptom Causes Action
1. Battery icon on
LCD on transmitter.
2. LCD display is
blank
3. LCD display shows
“funny” display
1. Low Battery 1. Replace batteries. Change
batteries every 6 months.
2. Check battery installation or
replace batteries.
3. Press Reset button at the back of
the transmitter.
4. Appliance does not
come on.
1. Wiring / Electrical Connections 1. Slide the switch to ON, if
appliance comes ON, wiring is
not the cause.
2. If appliance does not come on,
check wiring connections.
2. Privacy (DIP) switch setting on transmitter
does not match receiver
1. Make sure the transmitter and
receiver have the same DIP
switch settings.
3. Transmitter measures temperature exceeding
99 degrees Fahrenheit and shows “HI” on LCD
1. Move transmitter to a cooler
place and wait until temperature
drops below 99 degree.
4. Distance between the transmitter and receiver
is more than 30 feet
1. Make sure the operating distance
is less than 30 feet
5. Receiver cannot
receive signal.
1. Receiver is installed in an enclosure 1. Make sure the receiver is not
located inside to tight of an
enclosure.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.