User's Manual

50D0098 RCSITE Installation & Operating Manual
Rel 0 Dec 2005
Page 6 of 10
Ambient Technologies
A Division Of Monessen Hearth Systems
Manual Mode:
1. Press the ON button once to turn on the appliance with max flame height.
2. Press the OFF button to decrease flame height. The first two pressing will
decrease flame height to lower level. The third pressing will turn fireplace off.
3. If holding on OFF button for more than 3 second, fireplace will be shut off.
Thermostatic Mode:
1. Press the AUTO button to enter the thermostatic mode.
2. In thermostatic mode, press the ON / ∆ button or OFF / ∇ button to set the desired
set temperature.
3. Once the setting is completed, the transmitter will automatically turn on the
fireplace when the room temperature is below the set temperature and turn off the
appliance when the room temperature is above the set temperature within 1
degree.
4. There will be a slight delay in the response of the unit (on/off) to a temperature. Room temperature is
monitored every 3 minutes.
5. Press the Auto button to exit the thermostatic mode. The transmitter will be in the manual off mode and the
fireplace will be shut off.
Flame Height Setting for Thermostatic Mode:
1. Hold AUTO button for 5 second and one number and flame icon will show up
in LCD screen, as show in the right figure.
2. Use the ON / ∆ or OFF / ∇ button to set the desired flame height to 1 (Min), 2
(Medium) and 3 (Max)
3. If there is no input within 3 seconds, the new setting will be transmitted to
receiver. This setting only affects auto mode operation.
4. The default setting for transmitter is 2 (Medium), as shown in left picture.
Low Battery Detection:
1. Battery voltage is checked once a minute. When the battery voltage drops to a
certain level, the low-battery icon will display on LCD, and the transmitter will
turn off the appliance. The transmitter will not function anymore until fresh
batteries are installed.
2. When the batteries are low, the LCD displays a low battery indicator. The low
battery indicator will be displayed in any mode.
3. The transmitter will not operate with low batteries. Change the batteries before the batteries are too weak
for normal operation. TURN THE UNIT OFF BEFORE REPLACING BATTERIES.