RCM ON/Off Remote Control Moz M INSTALLATION AND OPERATING INSTRUCTIONS This on/off remote control system provides a safe, reliable, and user-friendly remote control for millionth valve gas heating appliances. The system can be manually from the transmitter. It can be used with any millionth gas valve system. Always check with the owner's manual of the appliance before connecting this remote control system to it. Carefully inspect the contents for shipping damage.
WARNING Important Safety Information * Read this manual thoroughly prior to installing, programming or operating this remote control * This thermostat is designed for use with millionth gas valve system.Do not use this remote control systems on applications with voltages above 30 Volts AC. ¢ This remote control system requires three (3) “AAA” and four (4) “AA” alkaline batteries to provide power for the transmitter and receiver respectfully to properly control the system operation.
INSTALLATIONS Remote Receiver: The remote receiver may be wall mounted or installed in the appliance per the instructions in the specific appliance manual. Refer to the Homeowner’s Manual for special installation instructions. If wall mounted, the remote receiver must be installed in a junction box along with cover plate provided. Failure lo follow the installation instructions found in the appropriate Homeowner's Manual will void the warranty and may pose a fire hazard.
Setting Privacy (DIP) Switch On Receiver: ee Dip Switch The remote receiver privacy (DIP) switch was preset at the ) pad (Default) factory. A private code can be set into the system to prevent yd N accidental operation by other transmitters in the vicinity using ; the following procedure: / L. Slide the code switches to your choice of ON or OFF [ | position. The factory setting is switch #1 to #6 set and #7 and #8 set to OFF. Ny 2.
OPERATIONS: Transmitter: Transmitter Keypad Layout: Key Function ON Lin clock setting mode, select next item to adjust 2. in normal mode increase flame 3. in normal mode press ON+OFF>3 seconds enter or exit childproof QFF 1. in clock setting mode, increase the select item 2, in normal mode decrease flame 3.
1t takes some time for the receiver to respond to the transmitter. Do not press the Auto On/ Off buttons more than once within 5 seconds for correct operation. Low-battery detection: f. Battery voltage is sampled every | minute. When the battery voltage drops to a certain level, the low battery warning will come out., and the transmitter will turn off the appliance. The transmitter will not function anymore until fresh battery are installed. 2. During battery law condition, LCD shows low battery indicator.
3. Slide the 3 position button on the remote receiver to the ON position. The main gas flame should ignite . Slide the button to OFF. The flame should extinguish (the pilot light will remain on). 5. Slide the button to RS (the center position), then press the button on the transmitter to change the stern to ON. The main gas flame should ignite. 6. Press the [OFF] button on the transmitter to change the system to OFF. The flame should extinguish (the pilot life will remain on).
TROUBLESHOOTING Symptom Causes Action 1. LED lighten receiver blinking or battery icon on LCD on transmitter. 2. LCD display is blank 3. LCD display shows “funny” display 1. Low Battery 1. Replace batteries. Recommended change batteries every 6 months 3. Press Reset button at the back of the transmitter. The rest button is located at the lower left corner behind the battery cover. 1. Appliance does not come on after pressing on transmitter 1. Wiring / Electrical Connections 1.
