Data Sheet

Mesh Networking Module CTL3212

Rev. 2

A fixed device is defined as a device is physically secured at one location and is not able to be

easily moved to another location.

Note 2: Host product manufacturers must provide in their user manual the required RF exposure

information for mobile & fixed usage of this module. Host product manufacturers must use the

following RF exposure statement in their user manual “This equipment complies with FCC radiation

exposure limits set forth for an uncontrolled environment. This equipment should be installed and

operated with a minimum distance of 20 cm between the radiator and all persons. This transmitter

must not be co-location or operating in conjunction with any other antenna or transmitter.”

Note 3: Any modifications made to the module will void the Grant of Certification, this module is

limited to OEM installation only and must not be sold to end-users, end-user shall have no manual

instructions to remove or install the device, only software or operating procedure shall be placed in

the end-user operating manual of final products.

Note 4: Additional testing and certification may be necessary when multiple modules are used.

Note 5: The module may be operated only with the integral chip antenna with which it is authorized.

Note 6: To ensure compliance with all non-transmitter functions the host manufacturer is

responsible for ensuring compliance with the module(s) installed and fully operational. For example,

if a host was previously authorized as an unintentional radiator under the Supplier’s Declaration of

Conformity procedure without a transmitter certified module and a module is added, the host

manufacturer is responsible for ensuring that the after the module is installed and operational the

host continues to be compliant with the part 15B unintentional radiator requirements. Since this may

depend on the details of how the module is integrated with the host, the manufacturer shall provide

guidance to the host manufacturer for compliance with the part 15B requirements.

Note 7: The FCC ID label on the final system must be labeled with “Contains FCC ID: 2AAUQ-

CTL3212” or

“Contains transmitter module FCC ID: 2AAUQ-CTL3212”.

Note 8: The FCC rule/s for this module are CFR 47 Part 15 Subpart C.

Note 9: This modular transmitter is only FCC authorized for the specific rule parts listed on its grant.

The host product manufacturer is responsible to any other FCC rules that apply to the host not

covered by the modular transmitter grant of certification. The final host product will require Part 15

Subpart B compliance when the modular transmitter is installed.

16.2 ISED Statements`

This device complies with Innovation, Science and Economic Development Canada’s

license-exempt RSS standard(s). Operation is subject to the following two conditions:

1) this device may not cause interference, and

2) this device must accept any interference, including interference that may cause

undesired operation of the device.