User's Manual

Ju
ly
5
,
201
2
Page
47
of
49
66 8003 002
-
7
Enabling EMI events via Lock Service
1. Go to Start/Programs/
Lock Service/Lock Service .
2. Choose Configure lock
in the left pane of the
Lock Service window.
3. In the drop-down-menu,
choose ‘Enable EMI events’.
4. Plug the applicable service cable
into the lock (may be another
service cable than 205 999 005
depending on lock type) and click
the Set button in Lock Service.
Checking EMI events in Lock Service
1. Choose Parameters in the left pane
of the Lock Service window.
2. Make sure that ‘EMI events’ is
shown under the General tab.
Logging EMI events in Orion Service
If desired:
1. Provoke some EMI events in
the lock, e.g. ‘Door closed’
and ‘Motion detected’.
2. Go to Start/Programs/
Orion Service/Orion Service .
3. Choose Log under the Readout
section in the left pane; choose
the applicable No. of events .
4. Plug the service cable into
either the wired thermostat
or the thermostat controller,
depending on configuration.
5. Click the Readout button in
Orion Service.
6. Ensure that the door and motion
events (e.g. ‘Door closed’ and
‘Motion detected’) are logged as
in the example picture to the right.