User's Manual

Ju
ly
5
,
201
2
Page
43
of
49
66 8003 002
-
7
Scenario with thermostat controller and battery thermostat
1. Go to Start/Programs/
Orion Service/Orion Service .
2. Choose Configure device in the
left pane of the Orion Service window.
3. Plug the service cable into the
thermostat controller.
4. Choose the Coordinator tab.
5. Click Form new network .
6. Click the Get network button; the
thermostat controller will appear
in the window below Get network .
7. Put the cursor on the thermostat
controller in the Orion Service window;
an information box, showing e.g. the
channel for the thermostat controller,
will appear. If the channel should be
changed, click the applicable channel
(in the picture example ‘26’) and click
the Set channels button.
8. Mark the thermostat controller and
click the Permit join button.
9. Right click on the thermostat controller
and choose Get user description .
Information about the thermostat controller
will be shown; see picture to the right.
Make sure that
- the channel is correct
- it says ‘yes’ at
‘Join permitted’
Note: If it does not say ‘yes’
at ‘Join permitted’, click the
Permit join button again.