User's Manual

Ju
ly
5
,
201
2
Page
4
1
of
49
66 8003 002
-
7
7. Put the cursor on the thermostat in the
Orion Service window; an information
box, showing e.g. the thermostat channel,
will appear. If the channel should be
changed, click the applicable channel
(in the picture example ‘26’) and
click the Set channels button.
8. Mark the thermostat and click the
Permit join button.
9. Right click on the thermostat
and choose Get user description .
Information about the thermostat will
be shown; see picture to the right.
Make sure that
- the channel is correct
- it says ‘yes’ at ‘Join permitted’
Note: If it does not say ‘yes’
at ‘Join permitted’, click the Permit join
button again.
10. Plug the service cable into the
motion sensor.
11. Choose the Motion sensor tab
and click Discovery .
12. Plug the service cable into the thermostat.
13. Choose the Coordinator tab and click
Get network .