User's Manual

Ju
ly
5
,
201
2
Page
40
of
49
66 8003 002
-
7
Adding the lock to the in-room network
The in-room network is configured under the Configure device section in Orion Service.
Configuration Description
Form new network This configuration removes all nodes in the PAN and resets the coordinator.
Permit join When this configuration is used, an in-room device (RF door switch,
motion sensor or lock) can join the coordinator.
Forbid join When the RF door switch, motion sensor or lock has joined the coordinator,
this configuration should be used on the coordinator.
Note: If the Forbid join command is for some reason forgotten, it will
automatically be executed 15 minutes after the Permit join command
was executed.
Set channels Default is that all channels are ON (the ‘1’ indicates ON); the best channel will
automatically be chosen, so normally the Set channels command is not needed.
Get network This configuration shows the in-room network.
Note: When hovering with the cursor over an item in the network, the tooltip
will show what type of item it is; e.g. ‘Coordinator’ as in the screenshot example
above. The tooltip will also show e.g. IEEE address and firmware version.
Scenario with wired thermostat
1. Go to Start/Programs/
Orion Service/Orion Service .
2. Choose Configure device in the left
pane of the Orion Service window.
3. Plug the service cable into the thermostat.
4. Choose the Coordinator tab.
5. Click Form new network .
6. Click the Get network button; the
thermostat will appear in the window
below Get network .