User's Manual

USING THE IR/RF COMMAND CENTER

The One For All IR/RF LCD 8-Device With Learning Universal

Remote Control (URC-9910) comes with an IR/RF Command Center

which receives radio-frequency (RF) signals from the URC-9910

remote control, anywhere in your home, up to 100 feet away. Once it

is set up, the IR/RF Command Center will convert the RF signals into

Infrared (IR) signals to control your home theater devices.

NOTE: The URC-9910 remote control transmits both an IR and an RF signal

simultaneously. It is your option whether you want to install the IR/RF

Command Center for extended remote control range. If you choose to do so,

during testing do not aim the URC-9910 remote control at your home enter-

tainment devices to verify that RF transmission is working.

NOTE: The RF signal transmitted by the URC-9910 remote control, only

works with the IR/RF Command Center.

Setting Up The IR/RF Command Center

1. Find a location approximately 8 feet in front of your

home theater devices.It should provide (line-of-

sight) access to your equipment and a power outlet

to plug in the IR/RF Command Center.

2. Plug in the IR/RF Command Center’s power cord and

raise the telescoping antenna.

Tel e sco p ing

Antenna

IR Lens

3. Position the IR/RF Command Center so the black

IR Lens is aimed at your home theater devices.

4. To test the IR/RF Command Center,take the

URC-9910 remote control into another room in your

home,up to100 feet away. Select a device key (e.g.,

TV) and press it once.Then press POWER once. The

device (e.g., TV) should turn on.

If it does not turn on, review the steps 1 through 3

and make any adjustments. Try step 4 again. If you

continue to have a problem, perhaps there is an IR

line-of sight problem. Try adding the enclosed IR

Signal Extension Cord (see next page).Also review

the tips in Optimizing IR/RF Command Center

Reception on page 54.

Producer 2002 RF Mnl 4/4/02 10:17 AM Page 52