User's Manual

Network RFID Encoder Installation and Operation Instructions Pg. 7 of 13
© SAFLOK™, all rights reserved. WL 2/6/2009
CA5 POWER UP MENU
1.Start Program
2.Terminal Settings
3.Display Version
4.Load/UnLoad Files
Setup for RS232 (serial) Connection with DeskLinc™
1. Connect the RS232 cable to the encoder (see Fig. 2) and the hand-held terminal. The thin 90-degree
plug inserts into the top side of the hand-held terminal the other end plugs into the back of the
encoder unit.
2. Plug the power supplies for the hand-held terminal and encoder into a wall socket.
3. Once the terminal's batteries tab have been removed and the power supplies for the hand-held
terminal and encoder are connect to a wall socket, it will display the “Power Up” menu screen.
4. To start the program, simply press ENTER. The terminal should begin communicating with the
encoder right away. If the terminal is communicating, the encoder’s blue RS232 Link (LNK) light will
be on solid. If this does not occur, reference your DeskLinc manual for troubleshooting. The terminal
will display the Password or Sign On screen.
Fig. 2
RS232
Connection