Manualshelf

User's Manual

ManualsBrandsComputerized Security Systems ManualsElectronicsRFID card reader/encoder used to access security devices
12345678910
Network RFID Encoder Installation and Operation Instructions Pg. 5 of 13
© SAFLOK™, all rights reserved. WL 2/6/2009
Setup for TCP/IP Connection with System 6000 (continued)
4. When the MAC address appears on the screen double
click on it and it will move it up to the MAC Address
input line. Click Configure to send the information to the
encoder.
5. When encoder receives the information the message
above will appear. Click OK. Reset the power to the
encoder for changes to take effect. Then click Close.
6. Click on Test For Encoder and the screen
below will appear.