User's Manual

Network RFID Encoder Installation and Operation Instructions Pg. 3 of 13

Setting Up the Encoder

1. Connect the power cable to the encoder (located on the back of the unit, as shown in Fig. 1). Use a

SAFLOK 12V DC power supply, part number 73763.

2. Connect the communication cable to the appropriate communication port on the back of the encoder

Ethernet network (TCP/IP), DeskLinc serial port (RS232), or PC (USB).

3. Plug in SAFLOK power supply to an electrical outlet.

4. Refer to the appropriate section to complete the setup:

• TCP/IP instructions (System 6000) – page 4

• Serial instructions (DeskLinc) – page 7

• USB instructions (System 6000) – page 8

Fig. 1

Network RFID Encoder Connections

(back of the unit)