User's Manual

Quantum™ RFID Pg. 5 of 6

Testing Lock Functionality

Pass a Construction key over the Quantum RFID LPI probe. Be sure that the green light flashes for five

seconds while the exterior lever remains operable. If the green light does not flash, refer to the table

below.

Lock Communication Electronic Function Description

Red and green LEDs flash Time and date not set, use the Quantum RFID LPI probe to reset

nine times simultaneously

Yellow LED flashes 12 times Dead bolt is thrown or switch cam is not properly aligned

Yellow LED flashes two times Keycard not allowed OR keycard cancelled by new keycard

Red and green LEDs flash Low battery (contact the SAFLOK service department)

alternately nine times

Yellow and red LEDs flash Bad keycard read or corrupted data (may require new

two times simultaneously keycard)

Red LED flashes two times Keycard not read (keycard inserted upside-down, wrong end,

wrong key?)

SAFLOK Door Unit Inspection Criteria

Appearance

Finish is free of blemishes or scratches that would distract from lock appearance

Lock body and under plate (if used) are mounted straight on the door

Door scalp is mounted straight and flush with the door edge

Jamb strike is mounted straight and is flush with the jamb face

Correction of minor blemishes on the door jamb are the responsibility of the property’s maintenance

department

Lock Function

Knob or lever rotates and moves freely

Lever is horizontal to floor when at rest position

Dead bolt extends fully and retracts without binding (door open)

Lock latch and dead bolt engage jamb strike plate freely

Anti-pick latch when depressed (door open)

Anti-pick latch is depressed when contact is made with the strike plate (door closed)