USER’S GUIDE COLOR MONITOR Model No : 7cln CTL S/N:9978626503
IMPORTANT SAFEGUARDS 1. Read all of these instructions. 2. Save these instructions for later use. 3. Unplug this monitor from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Do not use attachments not recommended by the monitor manufacturer as they may cause hazards. 5. Do not use this monitor near water, e.g., near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc. 6.
The power cord is used as a main disconnect device. Disconnect the power cord before servicing. The outlet must be installed near the monitor and must be easily accessible. As an ENERGY STAR Partner, Computer Technology Link, Inc. has determined that this product meets the Energy Star guidelines for energy efficiency.
CONTENTS Introduction ............................................................................. 1 Product Features ................................................................. 2 Setup ......................................................................................... 3 Installing the Tilt/Swivel Stand ........................................... 3 Connecting the Signal Cable and Power Cord..................... 4 Power Management System ...............................................
SETUP PRODUCT FEATURES • The convenient and user-friendly on-screen display allows for easy and accurate adjustments of horizontal and vertical screen size and position, geometry and screen color. • The monitor supports a safe working environment in strict compliance with the MPR II standard for low emissions. • The monitor complies with the VESA Display Data Channel (DDC) specification for Plug and Play compatibility. Advanced microcircuitry makes setup and configuration fast and effortless.
CONNECTING THE SIGNAL CABLE AND POWER CORD 1. Turn off the computer and monitor. 2. Connect the 15 pin D-sub connector to the output port of the video card in your computer. 3. Tighten the screws of the connector. 4. Plug the power cord into the AC receptacle located on the back of the monitor. 5. Plug the other end of the power cord into the AC outlet.
OPERATION & ADJUSTMENT Key Process Control Panel ENGL SH DEUTSCH ESPAÑOL FRANCA S TAL ANO • Move cursor to the right window on the OSD window. • Increase the value of any selected function. • Move cursor to the left window on the OSD window. • Decrease the value of any selected function. • Launch OSD(On-Screen Display) MENU window. MENU • Move cursor to the high window on the OSD Start window. • Increase the value of V.size or V.center. • Move cursor to the low window on the OSD window.
OSD Functions ICON ICON CONTROL FUNCTIONS CONTROL FUNCTIONS H. MOIRE Adjust the horizontal picture moire cancellation. V. MOIRE Adjust the position of the display horizontally(left or right) and vertically (up or down). Adjust the vertical picture moire cancellation. FOCUS Adjust the focus image. COLOR TEMP Choose different preset color temperatures or set your own customized color parameters. ZOOM Adjust the display width & height at the same time. RED GAIN Adjust the red gain.
SPECIFICATIONS ICON CONTROL FUNCTIONS STATUS Display horizontal & vertical frequency and polarity. POWER SAVER YES : VESA DPMS operation. NO : NO DPMS operation. TEST PATTERN Display a RGB Color Bar to determine whether the screen color is expressed normally or not. RECALL Reset the screen to the Factory Preset Display Settings. Self Diagnosis When the monitor doesn’t display, if you press any key, Self Diagnosis screen is displayed.
DESCRIPTION FOR D-SUB CONNECTOR TROUBLESHOOTING Symptom No picture. Check Check if power switch and computer power switch are in the on position. Check if the signal cable is correctly connected to the video card. Check if the pins of D subconnector are not bent. Check if the computer is in the power- saving mode. POWER LED is not Check if power switch is in the on position. lit. Check if the power cord is correctly connected. Image is unstable. Check if the signal cable is suitable to the video card.
