User guide
Safety and Warranty
•
Please read these safety instructions carefully.
•
Please keep this user's manual for later reference.
•
Please disconnect this equipment from any AC outlet before cleaning. Do not use liquid or spray
detergents for cleaning, use a damp cloth.
•
For pluggable equipment, the power outlet must be installed near the equipment and must be easily
accessible.
•
Keep this equipment away from humidity.
•
Put this equipment on a reliable surface during installation. Dropping it or letting it fall could cause
damage.
•
The openings on the enclosure are for air convection. Protect the equipment from overheating. DO
NOT COVER THE OPENINGS.
•
Make sure the voltage of the power source is correct before connecting the equipment to the power
outlet.
•
Position the power cord so that people cannot step on it. Do not place anything over the power
cord.
•
All cautions and warnings on the equipment should be noted.
•
If the equipment is not used for a long time, disconnect it from the power source to avoid damage
by transient over-voltage.
•
Never pour any liquid into an opening. This could cause fire or electrical shock.
•
Never open the equipment. For safety reasons, only qualified service personnel should open the
equipment.
•
If any of the following situations arises, get the equipment checked by service personnel:
o
The power cord or plug is damaged.
o
Liquid has penetrated into the equipment.
o
The equipment has been exposed to moisture.
o
The equipment does not work well, or you cannot get it to work according to the user’s manual.
o
The equipment has been dropped and damaged.
o
The equipment has obvious signs of breakage.
•
Do not leave this equipment in an uncontrolled environment where the storage temperature is
below -20° C (-4° F) or above 60° C (140° F), as this may damage the equipment.
Unpacking
After unpacking the DisplayPac-WN, check to ensure the following items are included and in good condition. Do
not attempt to apply power to the system if there is damage to any of its components.
•
1x DisplayPac-WN main system
•
1x Power adapter
•
1x Power cord
•
1x Touch Driver CD (optional)
•
Mounting screws (optional)
DisplayPac-WN Hardware User Guide iii