User Manual Part 2
Table Of Contents
- 7. Recording Options
- 8. Display Options
- 9. Reading a CATC Trace
- 10. Decoding Higher Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Changing Protocol Assignments
- 11. Other Features
- 12. How to Contact CATC
- 13. Warranty and License
53
Merlin Protocol Analyzer User’s ManualCATC Version 1.6
screen, then direct your piconet Master device to connect to Merlin. The
Master will attempt to connect to Merlin and therein give Merlin the
information it needs to record the Master and slave devices.
Step 17 Type in an address of your choosing for Merlin (= Page Target).
You are making up an address for Merlin that the Master will use to try
to connect to Merlin.
Step 18 Press Next
Merlin will then display your current settings.
The Advanced button will open the Recording Options dialog box
shown on page 42 and described in detail in Chapter 7.
Step 19 Press Next to begin the recording.
If the Merlin hardware is not ready or connected or is in the process of
booting up, the following information message box will display:
Step 20 If the above information box opened, press OK to close it.