User Manual Part 2
Table Of Contents
- 7. Recording Options
- 8. Display Options
- 9. Reading a CATC Trace
- 10. Decoding Higher Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Changing Protocol Assignments
- 11. Other Features
- 12. How to Contact CATC
- 13. Warranty and License
52
Merlin Protocol Analyzer User’s ManualCATC Version 1.6
The screen that follows will depend on the options you selected above.
If you selected the first option (=’Sync & Record’), the following screen
will display. This screen gives you the option of verifying the presence
of the Master device just before synchronizing.
Step 16 If you want to skip the Master verification, put a check in the
box. If you are in doubt, leave the box unchecked.
If you selected only the second option in Step 15 (=’Passive Sync &
Record’), the following screen will display.
This screen asks you for the address of the Page Target device -- which
in this case is Merlin. Since the devices in your piconet are not able to
respond to inquiries, Merlin will not be able to page the devices and join
the piconet. Instead, you will assign Merlin an address here in this