User Manual Part 2

66
Merlin Protocol Analyzer User’s ManualCATC Version 1.6
Master device. When the piconet Master pages Merlin, Merlin obtains the
information necessary for synchronization and then attempts to synchronize
to the piconet controlled by that Master.
"Passive Sync and Record" is designed to be used with established piconets
or private device networks.
Running "Passive Sync and Record" with Established Piconets
For most situations, "Passive Sync and Record" will be run after a piconet
has been established. The steps are as follows:
Step 1 Establish a connection between two or more Bluetooth™
devices.
Step 2 Under General Recording Options, select "Passive Sync and
Record."
Step 3 Under the Modes tab in Recording Options, enter the address for the
piconet’s master device.
Step 4 Make up an address for Merlin and enter it into the Page
Target address in the Modes tab in Recording Options.
Make sure you do not select an address for any other local
device.
Step 5 Press the REC button on the toolbar in Merlin to start a
recording session.
Step 6 If necessary, have Master "discover" Merlin through a
General Inquiry.
Step 7 From the Master device, initiate a page to Merlin’s address.
This action will enable Merlin to synchronize to the piconet.
However, the analyzer will not complete the page sequence
from the Master. This will cause the Master to time out in
this request.
Step 8 At the end of this sequence, the green Sync light will go on
solid, recording will begin and activity will be displayed on
the status bar in the bottom of the analyzer screen.