User Manual Part 2
Table Of Contents
- 7. Recording Options
- 8. Display Options
- 9. Reading a CATC Trace
- 10. Decoding Higher Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Changing Protocol Assignments
- 11. Other Features
- 12. How to Contact CATC
- 13. Warranty and License
54
Merlin Protocol Analyzer User’s ManualCATC Version 1.6
The following dialog box will display:
Step 21 Press Retry or Back to re-attempt the process.
If the hardware failure described in Steps 20 and 21 do not occur, Merlin
will conduct an inquiry. The screen will show that Merlin is going to
attempt a recording in either ’Passive Sync & Record’ mode as shown
below or in ’Sync & Record’ mode depending on the options you
selected in Step 15.
Step 22 If you are recording in ’Passive Sync & Record’ mode, you will
need to direct your Master device to attempt a connection to Merlin.
This will provide Merlin with the information it needs to record the
piconet.