User Manual Part 1

16
Merlin Protocol Analyzer User’s ManualCATC Version 1.6
• Minimum of 16MB physical RAM; 32 MB recommended for viewing
transactions
• At least 10 MB hard disk space, plus additional memory for recordings
(as much as 200MB when recording a full buffer size)
• Monitor resolution at least 800x600 with thousands of colors
3.9 Merlin Program Installation
The CATC Merlin software is provided on three 3½ inch diskettes and
requires a Windows 98, Windows 98SE, Windows 2000 or Windows ME
operating system. If you are loading Merlin onto Windows NT 4.0 you will
get separate disk and instructions.
You would first need to install Merlin as a USB device and then install the
Merlin Windows application program.
Loading the Merlin USB Drivers
Step 1 Insert the Merlin program floppy for your operating system
labeled Disk 1 of 3 into the a: drive.
Step 2 Power-on the Merlin Analyzer.
Step 3 Connect the USB cable to the rear of the analyzer and to the
personal computer.
The host operating system detects the analyzer and begins to install the
USB driver.
Step 4 Follow the installation instructions provided on your screen
to complete the installation of the driver.
Note When Windows prompts you for a file, browse to the CATC floppy in the a: drive.
Installing the Merlin Application Program
Run Setup.exe from the Merlin floppy disk 1 of 3.
The CATC Merlin Install Wizard automatically installs the necessary files
to the computer’s hard drive. Merlin software is installed in the
C:\Program
Files\CATC\Merlin
directory unless you specify otherwise. Follow the
installation instructions on your screen.