User Manual Part 1

7
Merlin Protocol Analyzer User’s ManualCATC Version 1.6
2. Quick Installation
The Merlin Protocol Analyzer components and software are easily installed
and quickly ready to run on most Windows-based personal computer
systems. You can begin making Bluetooth™ recordings after following
these initial steps. However, if you are new to personal computers and
protocol analyzers, or if you are unsure about what to do after reading the
Quick Installation instructions, or if your analyzer does not work after you
follow these instructions, read through the subsequent sections in this
manual.
2.1 Setting Up the Analyzer
Step 1 Attach the Antenna to the ANT connection point. The
antenna should point up.
Step 2 Connect the AC power cable to the rear of the analyzer.
Step 3 Turn on the power switch on the rear of the analyzer.
Step 4 Insert the first Merlin diskette (Disk 1 of 2) into your
analyzing PC floppy disk drive.
Step 5 Connect the USB cable between the USB port on the back of
the analyzer and a USB port on the analyzing PC.
Step 6 Follow Windows on-screen Plug-and-Play instructions for
the automatic installation of the Merlin Analyzer as a USB
device on your analyzing PC (the first Merlin diskette
includes the required USB files).
2.2 Installing the Software
Step 1 Run the program a:\setup and follow the on-screen
instructions to install the Merlin application on the analyzing
PC hard disk.
Step 2 To start the application, launch the CATC Merlin program
from the Start Menu: Start>Programs>CATC>Merlin.