User's Manual
Table Of Contents
- 7. Display Options
- 8. Reading a CATC Trace
- 8.1 Trace View Features
- 8.2 Interpreting the Displayed Information
- 8.3 Tooltips
- 8.4 Set Marker
- 8.5 Edit or Clear Marker
- 8.6 Adding Comments to a Trace File
- 8.7 Expanded and Collapsed Data Formats
- 8.8 Hide Frequency Hops
- 8.9 Hide Nulls and Polls
- 8.10 Menus in Clicked Fields
- 8.11 Hide Unassociated Traffic
- 8.12 Hide Channel
- 8.13 Hide Duplicated Traffic
- 9. Searching Traces
- 10. Decoding Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Decoding via the Profiles Toolbar
- 10.10 Changing Protocol Assignments
- 10.11 Encryption
- 10.12 Re-applying Encryption Settings
- 11. Reports & Exporting Data
- Appendix A: Merlin II Clock Calibration
- How to Contact CATC
- Limited Hardware Warranty
170
Merlin II Protocol Analyzer User’s ManualCATC SW Version 2.30
Set marker 104
Setup
menu 21
Shortcuts, keyboard 33
Show markers 145
Show plumb Line 145
Signalling
message 128
Signals
input 77, 84
outputs, enabling 89
Size of buffer 66
Slave device, address 42
Slave switch 74
Snapshot 10, 65
Soft Bit Error, searching 116
Software
installation 8
overview 21
Special Interest Groups (SIGs) 1
Specifications 6
Statistics
real-time 147
Status
status bar 145
Status of Analyzer 32
Storage temperature 6
Summary
error 143
traffic 147
Support, technical 157
Switches 6, 74
Sync
and record 70, 71
loss error 84
loss of, searching 116
timeout, loss of 73
window 76
Synchronization, forced 73
Synchronize Piconet 42
T
Tabs
recording events 77