User's Manual
Table Of Contents
- 7. Display Options
- 8. Reading a CATC Trace
- 8.1 Trace View Features
- 8.2 Interpreting the Displayed Information
- 8.3 Tooltips
- 8.4 Set Marker
- 8.5 Edit or Clear Marker
- 8.6 Adding Comments to a Trace File
- 8.7 Expanded and Collapsed Data Formats
- 8.8 Hide Frequency Hops
- 8.9 Hide Nulls and Polls
- 8.10 Menus in Clicked Fields
- 8.11 Hide Unassociated Traffic
- 8.12 Hide Channel
- 8.13 Hide Duplicated Traffic
- 9. Searching Traces
- 10. Decoding Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Decoding via the Profiles Toolbar
- 10.10 Changing Protocol Assignments
- 10.11 Encryption
- 10.12 Re-applying Encryption Settings
- 11. Reports & Exporting Data
- Appendix A: Merlin II Clock Calibration
- How to Contact CATC
- Limited Hardware Warranty
168
Merlin II Protocol Analyzer User’s ManualCATC SW Version 2.30
Piconet
established devices 71
master address 52
private device 72
recording 42, 46
recording traffic on 36
search options 54
slave address 42
sync and record 71
synchronizing 42
target address 53
Wizard 43
PIN 136
Pkt 126
Polls
hiding 108
POLL packet 80
Position of trigger 66
Post triggering, percentage 66
PPP 126
Pre-triggering 66
Private Device Piconets 72
Program
installation 8
Progress indicator, recording 30
Protocol
Analyzer 2
decoding 126
searching 111
Pull-down menus 21
Pulse low signal 89
Pulse toggle signal 89
R
Reading a trace 103
Real time statistics 147
Record inquiry 76
Record menu 21
Recording
Bluetooth traffic 10, 92
existing Piconet 46
Piconet 42
progress indicator 30
reduced hop mode 56