User's Manual
Table Of Contents
- 7. Display Options
- 8. Reading a CATC Trace
- 8.1 Trace View Features
- 8.2 Interpreting the Displayed Information
- 8.3 Tooltips
- 8.4 Set Marker
- 8.5 Edit or Clear Marker
- 8.6 Adding Comments to a Trace File
- 8.7 Expanded and Collapsed Data Formats
- 8.8 Hide Frequency Hops
- 8.9 Hide Nulls and Polls
- 8.10 Menus in Clicked Fields
- 8.11 Hide Unassociated Traffic
- 8.12 Hide Channel
- 8.13 Hide Duplicated Traffic
- 9. Searching Traces
- 10. Decoding Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Decoding via the Profiles Toolbar
- 10.10 Changing Protocol Assignments
- 10.11 Encryption
- 10.12 Re-applying Encryption Settings
- 11. Reports & Exporting Data
- Appendix A: Merlin II Clock Calibration
- How to Contact CATC
- Limited Hardware Warranty
161
Merlin II Protocol Analyzer User’s ManualCATC SW Version 2.30
Symbols
!IXGEN_DONT_EDIT_THIS! 35
Numerics
1100 packet 80
1101 packet 80
A
Abort upload 32
Acknowledge 118
Action buttons 24, 85
Actions tab 85
Addr 104
Addresses
AM_ADDR 80
Bluetooth 52
slave device 42
target 53
Analyzer
describing Bluetooth 2
set up 7
status 32
API 3
Application installation 8
Arqn 104
ARQN condition 80
AT 126
Authentication 136
Automation Feature 3
AUX1 packet 80
B
Basic installation 7
Bit pattern, searching 121
Blue dot menus 88
Bluetooth
BusEngine 5
described 1
device address 52
first recording 10
limited search 76
recording traffic 92
search for device 48
searching for devices 38
target address 53
BNEP 126