User's Manual
Table Of Contents
- 7. Display Options
- 8. Reading a CATC Trace
- 8.1 Trace View Features
- 8.2 Interpreting the Displayed Information
- 8.3 Tooltips
- 8.4 Set Marker
- 8.5 Edit or Clear Marker
- 8.6 Adding Comments to a Trace File
- 8.7 Expanded and Collapsed Data Formats
- 8.8 Hide Frequency Hops
- 8.9 Hide Nulls and Polls
- 8.10 Menus in Clicked Fields
- 8.11 Hide Unassociated Traffic
- 8.12 Hide Channel
- 8.13 Hide Duplicated Traffic
- 9. Searching Traces
- 10. Decoding Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Decoding via the Profiles Toolbar
- 10.10 Changing Protocol Assignments
- 10.11 Encryption
- 10.12 Re-applying Encryption Settings
- 11. Reports & Exporting Data
- Appendix A: Merlin II Clock Calibration
- How to Contact CATC
- Limited Hardware Warranty
152
Merlin II Protocol Analyzer User’s ManualCATC SW Version 2.30
of a .csv file opened in Microsoft Excel.
11.11 Exporting Audio Data
Merlin II has an Export Audio Streams command that allows you to
extract audio data from a trace and export it into a file. The command lets
you narrow your selection to a particular stream direction (master to slave
or slave to master), and to set the output file format and output sampling.
Step 1 Select File > Export > Audio Streams from the menu.
The dialog box shown right opens.
Source Audio Format - Select the
Source format.
Output File Format - Select an
output format: WAVE or raw.
Stream Direction - Select stream
direction that you wish to capture:
Master to Slave, Slave to Master, or
both ("Combine M/S").
Output Sampling - Select a
sampling rate for the exported audio.
Step 2 Set the parameters, then click Save.
A Save As dialog opens.
Step 3 Select the name of the file to be
created and its location, then click OK.