User's Manual

Merlin II Protocol Analyzer User’s ManualCATC SW Version 2.30

Timeout (0-80 secs)

Default value for Inquiry Timeout is 20 seconds.

Correlation Value (33-64)

This value tells Merlin II how many bits in the sync word of each received

packet must be matched in order for Merlin II to consider the packet valid

and start recording.

This value specifies how long Merlin II should perform the Inquiry process

for the General (unlimited) and Dedicated (limited) recording modes. After

the specified time has elapsed, Merlin II will illuminate the trigger light on

the front of the analyzer.

BT Neighborhood

These options configure how the BT Neighborhood command behaves. BT

Neighborhood is a utility that performs an Inquiry and then lists the local

devices that it discovered.

• Use Default settings -- Sets the analyzer to record a General

Inquiry with an Inquiry Timeout of 11 seconds.

• Match 'Inquiry' Recording Settings -- Sets the analyzer to use

the settings you chose above under Hop Sequence, Inquiry Type,

and Additional Settings.

6.6 Recording Options - Events

If you have selected Event Trigger mode under the General tab in the

Recording Options screen, you may now select specific Bluetooth events

using the Events tab on the Recording Option Screen. You can also use the

Actions tab to define specific event sequences that will trigger Merlin II to

record a Bluetooth session.

In addition, the Events and Actions screens allow you to specify which

packets you want to include or exclude from the recording.