User's Manual

Merlin II Protocol Analyzer User’s ManualCATC SW Version 2.30

Step 10 Select or type in the Master device’s address into the box

next to the label Piconet Master Address.

Step 11 Press Next.

The following screen will display. This screen asks you which of the

following two options apply to your Master device. For some devices,

both options will apply.

You can select either or both options. They are not mutually exclusive:

If the Master supports inquiries while in a connected state, select the first

option. This will set Merlin II to use the 'Sync & Record' mode in its

attempts to synchronize to the Master. This will also cause the wizard to

skip to step 8.

If the Master can support piconets with multiple slaves, select the second

option. If you select this box alone (i.e., you leave the first box

unchecked), Merlin II will use the 'Passive Sync & Record' mode to

synchronize to the Master. The wizard will then advance to Screen 8*.

If the first checkbox was selected, Merlin II will use 'Sync & Record' no

matter what was set in the second box.

Step 12 If you want to skip the Master verification, put a check in the

box. If you are in doubt, leave the box unchecked.