User's Manual

Merlin II Protocol Analyzer User’s ManualCATC SW Version 2.30

The Wizard advances to the next screen which presents three options:

• I want to establish a new piconet and have Merlin II record traffic on that

piconet.

This option causes Merlin II to perform an Inquiry so it can discover

local devices and then establish a new piconet and record the piconet

traffic.

• I want Merlin II to record traffic on a piconet that has already been

established.

This option lets Merlin II record traffic from an already established

piconet.

• I am using Bluetooth Test Mode and want Merlin II to record traffic on

my test piconet.

This option lets Merlin II create either a single frequency range recording

of a range that you specify or create a recording of a limited hop

frequency range consisting of 5 frequency hops.

5.1 Recording a Traffic on a New Piconet

The New Piconet option shown in the previous screen presents users with

the means of recording the traffic from a new piconet. This option will

cause a sequence of screens to prompt you for information such as the

piconet Master address.