User's Manual
Table Of Contents
- Table of Contents
- 1. Overview
- 2. Quick Installation
- 3. Detailed Installation
- 4. Updates
- 5. Software Overview
- 6. Recording Wizard
- 7. Recording Options
- 8. Display Options
- 9. Reading a CATC Trace
- 10. Decoding Higher Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Changing Protocol Assignments
- 11. Other Features
- How to Contact CATC
- Warranty and License
- Index
68
BTTracer Protocol Analyzer User’s ManualCATC Version 1.0
Piconet Recording
The "Piconet Recording" option presents three choices for recording piconet
traffic: Sync and Record, Passive Sync & Record, and Page Sync & Record.
A Help button next to the menu briefly explains these options.
Page Sync & Record is the preferred option and should be used whenever
possible. If Page Sync & Record can not be used, then Sync & Record
should be used. Passive Sync and Record should be used only if the first
two options can not be used.
Hop Sequence
Until recently, local regulations in Japan, France, and Spain defined a
Bluetooth™ frequency range that was different than the range used by the
rest of the world. We have included the selections for organizations for
testing of devices developed before all frequencies were made available on
aworld-widebasis.
To set BTTracer to the correct Hop Frequency, select from the drop-down
menu one of the following choices: