User Manual

91
CATC MERLIN’S WAND 1.22 APPENDIX A
User’s Manual Command Generator Command Descriptions
Appendix A: Command Generator
Command Descriptions
A.1 HCI Command Descriptions
Note “N/A” means Not Applicable. This indicates that the specified
command does not have a parameter.
HCI Link Control Commands
Accept_Connection_Request
Used to accept a new incoming connection request. Execute this command
before connection request from another device. By default, all connection
requests are accepted.
Add_SCO_Connection
Will cause the link manager to create an SCO connection in addition to the
existing ACL connection.
Command Parameters Examples Comments
N/A
Return Events
Accept_Connection_Request_Complete
Command Parameters Examples Comments
HCI_Handle 0x0001
Packet Type 0x0080 Possible packet types:
HV1=0x0020
HV2=0x0040
HV3=0x0080
Return Events
Add_SCO_Connection_Complete
Add_SCO_Connection_Error