User Manual

4-6 Setting Up and Using Laser Alignment Fixtures
* If a minor error is present, the data being acquired may be marginal. The
data quality will depend on the error. If a major error is present, then some
kind of hardware or system problem exists. Therefore, the data being
acquired is rejected.
X (flashing)
Low battery 1st warning
(sensor head) - The Laser
Head has the ability to
monitor its own battery
power. The battery power is
checked periodically to
determine if it is below the
minimum acceptable power.
When the battery power
reaches 4.8 volts, the LED will
be flashed off for 0.5 sec. and
then flashed on for 0.5 sec.
Data is accepted when the
battery is this state.
Recharge sensor heads.
X
Major Error* Refer to “Laser Head Status
Screen” on page 3-8 for more
information on the error and
the required action.
X (flashing)
Low battery 2nd/final warning
(sensor head) - The Laser
Head has the ability to
monitor its own battery
power. The battery power is
checked periodically to
determine if it is below the
minimum acceptable power.
When the battery power
reaches 4.2 volts, the LED will
be flashed off for 0.5 sec. and
then flashed on for 0.5 sec.
Data is not accepted when the
battery is this state.
Recharge sensor heads.
LED Status Meaning Required Action
Green Yellow Red