User Manual

3-15
Options Key
Read/Set 82X5 Addressing
This option allows the user to read and set the address in the laser heads.
The user will be asked to turn off and on the laser heads one at a time while
the analyzer reads the addresses in the laser heads. Then the user will be
given the opportunity to change the laser head addresses. The laser head
addresses can be set from 1 to 10 with no two laser heads having the same
address. The default addresses have the A-head set to 1 and the B-head set
to 2.
To read and set the laser head addresses the direct connect cable must be
attached to each of the laser heads and the analyzer first.
Caution!
When connecting any device to the RS232 serial port located on the top
panel of the analyzer, the analyzer must be turned off.
With the direct connect cable connect, select Read/Set 82X5 Addressing
from under the Addressing Selection menu and the following menu will be
displayed with step-by-step instructions:
7