User Manual
3-9
Options Key
Note
Whenever a communication problem exists, the following
message will be displayed: “Attempting Laser Head Commu-
nication.” If this occurs, make sure:
1···· (If applicable), you are using the proper direct connect cable (Model
821510) and it has been properly connected to the analyzer.
2···· If applicable, you are using the proper wireless adapter (Model
8000RF) and it has been properly connected to the analyzer
3···· Both laser heads are turned on.
4···· The RF communication addresses for both the laser heads and
analyzer are set up properly.
5···· You are in the proper alignment application (ProAlign Plus) for the
laser heads (Models 8215 and 8225).
Pressing the Alt/0 (Alt/Space) key displays a screen with a complete status
and error code report from laser heads. If a “W” or an “X” appears under
a laser head column for a condition, as shown in the following figure, then
that condition exists for that laser head.
5