User Manual
1-23
Installing the Application
4. ···If the Main Menu is displayed, select the Config button to display the
Configuration screen. Otherwise, the Configuration screen is already
displayed.
5. ···If necessary, change the settings on the computer. Normally, you
should use a baud rate of 19.2k or 38.4k and one stop bit. Change the
COM port setting to match the COM port the communications cable
was connected to in step 1. Change the Analyzer Type setting to 8000
/ 8117, then press the OK button to accept the communications
configuration and display the Windows Downloader Main Menu.
6. ···On the UltraSpec analyzer, press the Utility key to display the Utility
Functions menu.
12
7.····Select System Setup and press Enter.
The following screen will be displayed.
13
8. ···Select Load Firmware and press Enter.