User Manual

3-28 Options and Hardkey Functions
Note
Printing to Virprint uses the same communications cable used
to load firmware and load/dump UltraSpec jobs to and from
the PC. It does NOT use the Model 720A Printer Interface.
1. ·· Connect the 25-pin male end of the Model 639 Communications
cable directly into the RS232 Port located on the top panel of the
analyzer.
2. ·· Connect the 9-pin female end of the Model 639 Communications
cable directly into your PC’s serial port.
3. ·· In the UltraSpec analyzer, select the proper printer type (i.e.
VRPRNT). See “Printer Type” for more information.
4. ·· Run the Virtual Printer program on your PC.
19
5. ·· From the Capture menu select a capture mode: Screen, File, or File
and Screen.
If you select Screen, the information from the analyzer is sent directly
to the computer screen.