User Manual
6-38 Acquiring Alignment Data
When the data transfer is completed, an “Analysis In Progress” screen sim-
ilar to the following is displayed while the data is curve fit to a sine wave. If
the fit is satisfactory (85% and above), you are shown the results by means
of a dual tolerance plot screen.
25
26
Note
For users who want to view the acquired data in more detail,
pressing the Page Down key when the dual tolerance plot is
displayed will access additional screens. Refer to “Additional
Data Detail” on page 5-34 for more information.
Otherwise, you are warned the data is “Unfit” (less than 85%). At this point
you should either repeat the data acquisition or try to manually condition
or edit the data. This built-in check helps alert you to the data losing reli-
ability in the misalignment calculations. Refer to “Additional Data Detail”
on page 5-34 for more information.