User Manual

5-5
General Overview
Referring back to the UltraMgr/UltraSpec analyzer overview figure, the
UltraMgr PC is shown as the master and the UltraSpec analyzer is shown
as a slave. This means that actual transactions between the UltraMgr PC
and the analyzer are controlled by UltraMgr. Although you must make the
following analyzer selections to prepare for a job transfer, (1) Utility (2)
Communications (3) Host PC Load/Dump, the analyzer plays a passive
role from that point on. The actual transfer is set up and controlled from an
UltraMgr screen.
Also, when you are using UltraMgr, you need to consider what actions are
necessary after jobs have been
created or changed (in the analyzer). As men-
tioned previously, actual Station and Machine assignments are made from
UltraMgr.
The following figure and table (next page) show how changes to the various
parameters affect the job type. Although job type is a software term, the job
type determines where the job will be dumped to within the alignment
database (to a Machine location or to the Unassigned area).
Machine Dimensions