User Manual

5-15
Job Definition
Note
If the job is defined within UltraMgr, the Mach ID, Mach Desc,
Station and Coupling cannot be modified within the analyzer.
Mach ID: - Up to 10 characters can be used to define a Machine ID code
for the machine being aligned.
Mach Desc: - By pressing any key on the keypad (except Page Up or Alt),
the highlighted block can be expanded. Up to 28 characters can be used to
describe the machine being aligned. Press the Up Arrow or Down Arrow
to go to the next section of Define Job (characters off the screen will not be
lost).
Station: - Press any numbered key to expand the highlighted block. Up to
32 characters can be used to describe the station where the machine is
located.
Coupling: - If machinery being aligned has more than one coupling, use
this section of Define Job to number them. Each coupling should have its
own unique number. An example would be a machinery train consisting of
a motor, a gearbox, and a compressor. The coupling between the motor
and gearbox should be 1 and the coupling between the gearbox and com-
pressor should be 2. Positive numbers up to 10 can be entered.
RPM: - A unique RPM exists for each coupling that is entered. If you have
a variable speed machine, enter the highest RPM at which the coupling will
be operated. Also, if a coupling design has shafts operating at different
speeds, enter the larger of the two. This parameter is used to establish align-
ment tolerances.
When finished, press the Enter key to continue.