User Manual

9-9
UltraSpec Analyzer Battery Maintenance
UltraSpec 8117 Analyzer Battery Recharge
To recharge the battery, plug the Model 93140 charger into a standard 115
VAC outlet, and then plug the charger jack into the battery charger input
located on the top panel of the UltraSpec 8117 analyzer.
1
The supplied battery charger will completely recharge the battery pack in
14 to 16 hours. If the batteries are continually allowed to remain in the
charge cycle for periods longer than 14 to 16 hours, battery degradation
will
occur. An occasional overcharge will not significantly reduce battery life;
however, leaving the batteries in the charge cycle over a weekend, for
example, is not recommended. Typically, the batteries should be placed in
the charge cycle (after the analyzer has been used for a full shift, for
example), allowed to charge overnight, and then removed from charge the
next morning.
The UltraSpec 8117 analyzer, with a fully charged battery, will operate con-
tinuously for at least eight hours. The actual time between recharge cycles
can be increased by turning the analyzer off when not in use.
power
supply
to AC
wall outlet
AC Power Adaptor