User Manual

9-7
UltraSpec Analyzer Battery Maintenance
Changing the UltraSpec 8000 Analyzer Battery
Removing the Battery
To change the battery pack:
1. Insure that the analyzer is Off, and that the battery charger is
not
connected to the analyzer.
2. Remove the two screws on the
sides of the analyzer located just above
the bottom edge (
not the screws on the bottom cover), and remove
the bottom cover.
3. Carefully remove the battery pack from the analyzer case, and
disconnect the 3-pin connector.
4. Connect the 3-pin connector from the new battery pack to the
analyzer, and insert the battery pack into the analyzer case. Insure
that the connector is placed on top of or beside the battery pack –
not on the bottom side.
5. Replace the bottom cover and screws (the top of the analyzer cover
fits into the slotted side of the cover).