User Manual

8-2 Application Information
• Documentation of work done for use in future alignment jobs
Early alignment methods involved using a straightedge along the coupling
rims. This is still a good procedure to use as a preliminary step. In fact, for
low speed machines, operated infrequently for short periods of time, it may
be all that is needed.
However, more complex machines require more than this. Feeler gages,
inside micrometers, and dial indicators are now used extensively for taking
precise alignment measurements and monitoring corrective moves. These
tools can give good results when used properly.
Mistakes, however, can cause errors in the alignment procedure. Errors
that commonly occur are:
• Failing to document the job setup, problems, findings, and data
• Failing to use good indicator brackets
• Failing to determine the correct amount of bracket sag
• Misreading the indicators
• Failing to detect sticking indicators
• Mistakes in recording and interpreting the data
• Errors in calculating the moves
• Errors in making moves
These types of errors are even more likely to occur when you have pressure
to complete the job quickly.
CSI’s alignment equipment can help you avoid these kinds of mistakes.
Our adjustable brackets are designed to fit most machines. Since there are
no axial projecting arms, bracket sag is zero. Misalignment readings are cal-
culated automatically and required moves are then displayed. If a serious
mistake is made, the system will prompt you for corrected entries before
moving on to the next step.
Completed jobs are easily documented. Documented jobs can then be
stored in UltraMgr, a PC-based, corrective technologies information man-
agement system. This documented history can be used to enhance trouble-
shooting, identify personnel candidates for additional training, reduce
alignment time, etc. See “UltraMgr” on page 8-8 for more information.
Chapter 8 Page 2 Friday, January 26, 2001 10:34 AM