Manual Chapter 5

6-33

Quick Spec

Quick Spec allows you to make a quick check of the alignment condition of

a machine with minimal setup and effort. If a machine is found to have

unacceptable alignment, the procedure can be readily converted to a full

alignment procedure and machine moves calculated.

Quick Spec is only

available in Pro Align and Pro Align Plus

To use Quick Spec, select the desired alignment method from the Align-

ment Setup menu which is accessed using the Options key. Then, set Quick

Spec to Yes. When in Quick Spec mode, the normal alignment main menu

is not shown; each new job begins ready to conﬁgure and acquire data.

Caution!

Entering Quick Spec mode will clear any existing job in the Current

Job area. A warning screen will give you a chance to cancel this action.

Note

Quick Spec is not available for the Dual Pass method or

straightness.