Manual Chapter 5

6-14 Acquiring Alignment Data
. 9
Note
A minimum of three data points over a 45º sweep arc is
required, but CSI recommends a minimum of 8 data points
(samples) acquired over a sweep arc of at least 90º.
When all the desired samples (36 max.) have been acquired, press the Enter
key to accept the data. An “Analysis In Progress” screen similar to the fol-
lowing is displayed while the data is curve fit to a sine wave. If the fit is sat-
isfactory (85% and above), you are returned to the main menu where the
data may now be viewed.
10