Manual Chapter 5

5-41

Machine Moves

After deﬁning the job, checking the foot pre-check, collecting alignment

data, and viewing the analysis of the alignment data, you are ready to see

what machine moves are required. This section shows the screens and

information that are available.

While in the Machine Moves section, in addition to viewing the required

corrections, you can watch them being made in live mode (and view six dif-

ferent solutions in each plane – horizontal and vertical). Within the vertical

and horizontal logs, you can see how the present alignment condition com-

pares to the tolerances goal you are shooting for.

Use the Enter key to ﬁrst view the Vertical Move, and then the Horizontal

Move. A bullseye on each of the move screens displays the corresponding

tolerances. The alignment readings and machine moves will be automati-

cally recorded when the Enter key is pressed to exit from the Horizontal

Move screen.

When the readings and moves are recorded, a screen listing the number of

readings recorded for the current alignment job (maximum of 20) will

appear for a few seconds. The number of readings recorded will also be dis-

played in the lower right of the Main menu screen.

Note

The alignment readings must be different from the previous set

for the current set of readings to be recorded.