Manual Chapter 5

5-22 Using UltraSpec Alignment - General Overview

Foot Pre-Check

When Foot Pre-Check is selected (from the main menu) and the Job Deﬁ-

nition screen is completed, a screen similar to the one below on the left will

be displayed. The screen that is displayed depends on the type of Foot Pre-

Check selected (Soft Foot or Frame Distortion Index [FDI]). For more infor-

mation, see the Appendix heading, “Foot Pre-Check Types” on page -1.

Use the Enter key to move to the Soft Foot/FDI Locator screen (on the

right). Ensure that the sensor heads are at the top (as shown) or, at the

bottom position (180°). After verifying that all hold-down bolts are tight,

press Enter to proceed to the Soft Foot/FDI Data screen shown below.

Use the Up/Down arrow keys to select the foot to be checked. In the screen

above, the right outboard foot of the generator has been selected. Press

Delete to start.