Manual Chapter 5

9-10 System Maintenance and Troubleshooting

Changing the UltraSpec 8117 Analyzer Battery

To change the UltraSpec 8117 analyzer’s battery pack:

1·····Make sure that the analyzer is Off, and that the battery charger power

supply is

not

connected to the analyzer.

2·····On the bottom of the analyzer, remove the two screws on the bottom

panel as shown below. Then remove the panel.

3·····Using the tabs on the sides of the battery pack, carefully remove the

battery pack from the battery compartment.

4·····Insert the new battery pack into the analyzer case, ensuring that the

strip contacts on the battery pack line up with the connection pins

inside the battery compartment.

battery pins