Manual Chapter 5

9-8 System Maintenance and Troubleshooting
Note
If the battery is hard to pull out, you may have to remove the
front cover of the analyzer. To do so, carefully slide the cover
downward until the cable connector is exposed. Disconnect
the cable and slide the cover on down until the battery is free.
After replacing the battery, reverse the process by sliding the
cover back up until the cable can be re-attached. Continue by
returning the cover to its original position.
Caution!
Do not change the battery pack with the battery charger connected as
damage may occur to the analyzer. Exercise caution when re-connecting
the 3-pin, polarized connector. Damage will occur to the connector if
forced in the incorrect orientation.