Manual Chapter 1

3-22 Options and Hardkey Functions

Press the Enter key to proceed to the Prediction screen.

This screen displays the estimated alignment condition if the speciﬁed

moves were to be performed. The upper graph shows vertical misalign-

ment, both offset and angular. The lower graph shows horizontal misalign-

ment, both offset and angular.

The targets indicate how close the machine vertical and horizontal posi-

tions are to being in tolerance. The center (bullseye) indicates an excellent

range. The middle ring represents an acceptable range. The outer ring rep-

resents >1 times and <2 times the acceptable range. No ring highlighted

indicates >2 times acceptable range.

This process may need to be repeated before a suitable solutions is found

to bring the alignment condition within tolerance.

The example above was shown using offset and angle tolerances. The Pre-

dict Mode can also be used with Jackshaft tolerances.

Face/Rim Correlation

Press the Enter key to view the Sensor Location screen.